F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
7. Remove the heater core from the heater air plenum chamber.
INSTALLATION
1. Position the heater core and heater core case seal in the heater air plenum chamber.
2. Install the heater core cover on the heater air plenum chamber and secure it with its seven attaching screws. Make sure the A/C plenum vacuum
harness is not trapped or pinched during the installation.
3. Connect the A/C plenum vacuum harness to its source connection.
4. Install heater water hoses on the heater core at dash panel in engine compartment. Do not overtighten the clamps.
5. Check coolant level and add coolant as required.
6. Check system for proper operation and coolant leaks.
7. Install glove compartment.
8. Check system for proper operation.
