F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
2. Lightly apply Gasket Maker E2AZ-19562-B or equivalent meeting Ford specification WSK-M2G348-A5 to the cylinder block surface and a 6
mm (1/4-inch) diameter bead to engine front cover and rear main bearing cap as shown. Also apply a bead at the parting line of engine front cover
and cylinder block. Position the one-piece silicone oil pan gasket to the cylinder block and press lightly until oil pan gasket sticks to surface.
Position the oil pan with oil pump and oil pump screen cover and tube to the chassis. Install the oil pump and oil pump screen cover and tube to
the cylinder block. Tighten attaching bolts to 30-43 Nm (22-32 ft. lbs.).
3. Position the oil pan to the cylinder block position oil pan flange reinforcement and install the attaching bolts. Tighten 1/4-inch bolts to 11-16 Nm
(8-12 ft. lbs.).
4. Place jack under engine and raise engine enough to remove blocks.
5. Lower engine and remove jack.
6. Install the oil level indicator tube and oil level dipstick.
7. Reposition the air conditioner lines, if so equipped. If removed, reinstall A/C compressor.
8. Install the front engine support insulator-to-front engine support bracket retaining nuts. Tighten nuts to 96-127 Nm (71-94 ft. lbs.). Connect the
manual kickdown linkage at the transmission. Install the driveshaft and coupling shaft assembly, and the muffler inlet pipe assembly.
9. Clean the oil filter mounting surface and install the oil bypass filter.
10. Lower the vehicle from the hoist.
11. Install the radiator and connect the two transmission oil cooler lines.
12. Install the fan blade and fan shroud, and then connect the lower radiator hose and upper radiator hose.
