F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Oil Pressure Sender: Service and Repair
REMOVAL
1. Disconnect the wire at the oil pressure sensor.
2. Prepare the new oil pressure sensor for installation by applying Pipe Sealant with Teflon(R) D8AZ-19554-A or equivalent meeting Ford
specification WSK-M2G350-A2 or a small amount of electrically conductive sealer to the threads.
3. Remove the oil pressure sensor from its mounting.
INSTALLATION
1. Immediately install the new oil pressure sensor. Tighten to 11-24 Nm (8-18 ft. lbs.).
2. Connect wire to oil pressure sensor.
3. Start the engine and check the operation of the oil pressure sensor.
