F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Throttle Body: Service and Repair
CAUTION: The throttle body for this vehicle is a sludge-resistant design and should not be cleaned. The special coating will be damaged if cleaning is
attempted.
REMOVAL
1. Remove air inlet hoses.
2. Disconnect throttle linkage at throttle ball and automatic transmission linkage, if so equipped, from throttle body.
Throttle Body
3. Disconnect electrical connector at Throttle Position (TP) sensor.
4. Remove four throttle body bolts.
5. Carefully separate throttle body from upper intake manifold.
INSTALLATION
CAUTION: If scraping is necessary, be careful not to damage gasket surfaces of throttle body and upper intake manifold, or allow material to drop into
intake manifold.
1. Install a new gasket between upper intake manifold and throttle body. Make sure gasket stays in place if alignment studs are not used.
2. Install throttle body to upper intake manifold.