F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
3. Remove the brake drum from the studs.
4. Using C-Frame and Clamp Assembly Tool T74P-3044-A 1, press the lug bolt from its seat in the axle flange. The lug bolt can also be removed by
pressing it out using an appropriate sized socket and C-clamp. Discard the lug bolt.
INSTALLATION
1. Insert new lug bolt in hole in flange. Rotate lug bolt slowly. Make sure serrations are aligned with those made by the original bolt.
2. Place four flatwashers over the outside end of the stud and thread the lug nut with the flat side against the washers.
3. Tighten the lug nut until the bolt head seats against the back side of the flange.
CAUTION: DO NOT use air tools. The serrations can be stripped from the stud.
4. Remove lug nut and washers.
5. Install brake drum and wheel.
6. Lower the vehicle.
