F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
11. Install the No. 8B forward clutch needle bearing.
NOTE:
-
Lightly lubricate the needle bearing with petroleum jelly to hold it in place during assembly.
-
The bearing large inner diameter radius must face inward.
12. Install the two new cast iron forward clutch cylinder seals in the grooves.
NOTE: Stagger the interlocking opening on the seals 180 degrees apart.
13. Install the No. 9A forward clutch thrust bearing.
NOTE:
-
Lightly lubricate the thrust bearing with petroleum jelly to hold it in place during assembly.
-
The black side of the bearing must face upward.
Forward Hub and Ring Gear
