F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise vehicle on a hoist and position suitable safety stands under vehicle.
2. Remove rear driveshaft.
3. Remove extension housing seal using Seal Remover T74P-77248-A and Impact Slide Hammer T50T-100-A.
4. Remove the extension housing bushing using Extension Housing Bushing Remover T77L-7697-D.
CAUTION: Do not damage any machined surfaces.
INSTALLATION
1. Inspect the counterbore of the extension housing for burrs. If necessary, remove burrs with an oil stone.
