F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
8. Install main control valve body over studs. Align manual shift valve with inner manual valve detent lever.
9. Attach main control valve body with two nuts using a 10 mm socket and 14 bolts using an 8 mm socket. Tighten to 9-11 N m (80-100 Inch lbs.).
NOTE: If separator plate reinforcing plate bolt has been used to retain valve body separator plate to case, reinstall after main control valve body
is attached.
10. Install accumulator body assembly over studs and attach with two nuts using a 10 mm socket and 11 bolts using an 8 mm socket. Tighten to 9-11
Nm (80-100 Inch lbs.).
