F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
Clutch Release Bearing: Initial Inspection and Diagnostic Overview
CLEANING
Wipe all oil and dirt off the clutch release hub and bearing. The clutch release hub and bearing is prelubricated and should not be cleaned with solvent.
On all vehicles, the clutch release hub and bearing are serviced as a single unit. Do not disassemble for inspection or replacement.
INSPECTION
Inspect the clutch release hub and bearing as follows:
-
Hold the clutch release hub and bearing and back plate. Rotate outer race while applying a compressive pressure. If bearing rotation is rough,
replace clutch release hub and bearing.
-
Inspect/remove any surface scoring or burrs that may impede the sliding motion of the clutch release hub and bearing on the transmission main
drive gear bearing retainer. Any scoring or burrs should be polished off with a fine grade emery paper.
