F 350 2WD Pickup V8-6.9L DSL (1983)
c.
Remove the release lever by pulling slightly in a rearward direction.
Figure 8
d.
Inspect the lever for wear at the "tips" of the "fork". Evidence of excessive wear at this point indicates incorrect lever geometry (see Figure
8).
This can result in binding of the release bearing. For 1984-86 vehicles, obtain a replacement fork. For 1983 vehicles, obtain a replacement fork and
pivot stud.
3.
Remove the transmission from the vehicle as outlined in Section 16-24 of the 1983 or 1984 Light Truck Shop Manual.
4.
Inspect the clutch bearing contact area of the input shaft bearing retainer (7050) for galling or gouges If there are any indications of abnormal wear