F 350 2WD Pickup V8-6.9L DSL (1983)
1.
Using the new notched gasket as a template, lay it on top of the original design gasket.
2.
Match all feed passages and bolt holes.
3.
Trace the notched portion on the original design level gasket.
4.
Remove the notched gasket and cut out the portion traced on the original design level gasket.
5.
Verify that the modification was done correctly by comparing the modified gasket with the notched gasket that was used as the template.
NOTE:
Do not use sealer or adhesive on pump case or gasket-to-pump surface. If the pump gasket notch is blocked, no fluid drainback is possible.
This could result in the fluid pressure unseating the front pump O-ring or fluid coming out the filler tube.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY
