F 350 2WD Pickup V8-7.3L DSL (1988)
Figure 5
6.
Place the valve shaft positioner, (E9TZ-2W125-A) over the valve shaft as shown in Figure 5. Make sure the shaft flat fits into the "D"-slot of the
positioner and that the shroud is fully seated over the valve casting.
7.
Re-install the nut saved in Step 1 on the valve shaft. Hold the valve shaft positioner and tighten the nut to a torque of 8-10 lb.ft. (11-14 N-m).
8.
Install an "Authorized Modification" decal on the brake booster listing the modification as follows: "HSPV REAR BRAKE OPERATION
MODIFIED".
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of alterations performed. Select a prominent place adjacent to
the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it
with a clear plastic decal shield.
Procedure "B"
