F 350 2WD Pickup V8-7.3L DSL (1988)
FIGURE 3
3.
Remove the barbed fitting and breather hose from the P.T.O. shifter cover, Figure 3.
4.
Add oil into the P.T.O. through the breather hole in the shifter cover until the oil begins to run out of the hole for the capscrew ("A").
5.
Reinstall the capscrew in the output shaft bearing cover of the P.T.O.
6.
Reinstall the barbed fitting and breather hose into the P.T.O. shift cover.
7.
Make sure all the capscrews are properly tightened. Refer to the P.T.O. owner manual for the correct torque specification.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES:
5700, 5970
