ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Fuel Injection Pump - TPS Sensor Service|Page 423 > < Fuel Pump Inertia Switch|Page 418
Page 1
background image

Throttle Position Sensor: Technical Service Bulletins
Fuel Injection Pump - TPS Sensor Service

FUEL INJECTION PUMP - 7.3L DIESEL ENGINE - THROTTLE POSITION SENSOR - NEW SERVICE PART AND PROCEDURE - ENGINES
BUILT AFTER 10/21/88

Article No. 90-2-9

LIGHT TRUCK:

1988-89 E-250, E-350, F-250, F-350, F SUPER DUTY

ISSUE:

An electronic throttle position sensor (TPS) is used on all E and F Series trucks with an E40D automatic transmission. The TPS and vacuum
regulator valve (VRV) serve the same purpose; they control the shift points of the automatic transmission. The VRV uses vacuum to control
the shift points, while the TPS sends a voltage signal that varies with the throttle position to the E40D automatic transmission.

ACTION:

If a fuel injection pump is received with the TPS installed (see chart below for applicable units) it must be removed prior to servicing the
pump. Use the following service procedure to remove and install the TPS.

7.3L ENGINES EQUIPPED WITH TPS

SERIAL

BREAK

EQUIPPED MODELS

NUMBERS

DATE

All Automatic Transmissions

630772 and

10-21-88

with Sea Level Altitude Pumps

Above

All Automatic Transmissions

631811 and

10-21-88

with High Altitude Pumps

Above

Fuel Injection Pump - TPS Sensor Service|Page 423 > < Fuel Pump Inertia Switch|Page 418