F 350 2WD Pickup V8-7.3L DSL (1988)
Clutch: Service and Repair
One-Way Clutch, A/T
Disassemble
CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean
automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with
petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.
One-Way Clutch Disassembled
1. Remove snap ring and bushing from rear of low reverse hub.
2. Remove rollers from spring assembly, then remove spring assembly from hub.
3. Remove remaining snap ring from hub.
Assemble
1. Install snap ring in forward snap ring groove in hub, as shown in the One-Way Clutch Disassemble image.
2. Position hub on bench with forward end down.
3. Install one-way clutch spring on top of snap ring.
4. Install a roller into each of spring assembly compartments.
5. Install bushing on top of spring assembly, then install snap ring.
