F 350 2WD Pickup V8-7.3L DSL Turbo VIN K (1994)
Door Window Regulator Control And Door Lock Switch Assembly
Installation
1. Install a new motor and drive assembly and engage the motor to the regulator. Tighten motor retaining screws to 5.6-9.6 N-m (50-85 in-lb).
2. Install two pieces of Pressure-Sensitive Waterproof Tape D6AZ-19627-A or equivalent body tape (25.4mm [1 inch] square) over drilled holes.
3. Connect power window motor wiring. Connect battery ground cable.
4. Remove glass prop and check window operation.
5. Make sure door drain holes are open.
6. Install trim panel.
