F 350 2WD Super Duty V10-6.8L (2009)
1. Remove the protective backing from the adhesive on the microphone and attach the microphone as shown in the illustration (Figure 10). Firmly press
the microphone into place. Ensure the microphone is parallel and adjacent to the dome lamp trim.
2. Lower the dome lamp assembly. Refer to WSM, Section 417-02 for additional information.
3. Route microphone cable up through existing hole in the headliner, and over to the passenger side A-pillar. It may be necessary to slightly drop
headliner to run microphone cable. Refer to WSM, Section 501-05 for additional information.
4. Install dome lamp assembly; ensure microphone cable enters the dome lamp trim directly behind microphone as shown.
5. Gain access to connector 934 in the right A-pillar. Refer to online WD for location and connector views.
6. Identify circuits VMM13 (YE-GN), RMM13 (BU), and DMM13 (shield) from C934. Cut the three circuits on the female side of the connector
(14334 harness).
7. Identify circuits CPL60 (BN-YE) and GD161 (BK-YE) from C934.
8. Splice the five jumper harness wires into the following circuits:
^
Blue jumper harness wire to CPL60 (BN-YE) and any black jumper harness wire to GD161 (BK-YE).
^
Ensure original circuits remain connected in splice.
^
Yellow jumper harness wire to VMM13 (YE-GN) and remaining black jumper harness wires to RMM13 (BU) and DMM13 (shield).
^
Only splice into the cut wires heading in the direction of the connector. Tape off and secure the other cut wire ends as they are no longer used.
9. Attach the microphone connector to the jumper harness connector.
10. Bundle and tuck the remainder of the microphone cable over the front of the headliner.
2008-2009 Fusion / Milan / MKZ
