F 350 2WD Super Duty V10-6.8L (2009)
Front Door Exterior Handle: Service and Repair
Exterior Front Door Handle
Exterior Front Door Handle
Removal and Installation
1. Remove the front door trim panel.
2. Position the water shield aside.
3. If equipped, disconnect the door lock cylinder disarm switch electrical connector.
4. Remove the body plug.
5. Remove the 2 exterior front door handle nuts.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the exterior front door handle.
1. Disconnect the lock cylinder actuating rod from the handle.
2. Disconnect the door handle actuating rod from the front door latch.
3. Remove the exterior front door handle.
7. To install, reverse the removal procedure.