F 350 2WD Super Duty V10-6.8L (2009)
18. NOTICE: Do not handle the passenger air bag module by grabbing the edges of the air bag trim cover. Failure to follow this instruction
may result in component damage and/or system failure.
Remove and discard the 4 nuts and position out the passenger air bag module from the instrument panel.
-
To install, tighten to 9 Nm (80 lb-in).
19. Disconnect the electrical connector and remove the passenger air bag module.
20. Install the RCM fuse 32 (10A) to the SJB.
21. Connect the battery ground cable.
Reactivation
1. Remove the RCM fuse 32 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. NOTICE: Match the electrical connector key to the keyway in the passenger air bag module. The passenger air bag module electrical
connector is unique and cannot be reversed when connected to the passenger air bag module. Do not force the electrical connector into
the passenger air bag module. Failure to follow these instructions may result in component damage and/or system failure.
Connect the electrical connector to the passenger air bag module.
4. NOTICE: Do not handle the passenger air bag module by grabbing the edges of the air bag trim cover. Failure to follow this instruction
may result in component damage and/or system failure.
NOTE: During installation, 4 new air bag module bolts must be installed.
NOTE: Check the positioning of the passenger air bag module J-nuts before positioning the passenger air bag module to the instrument panel.
Position the passenger air bag module in the instrument panel and install 4 new nuts.
-
Tighten to 9 Nm (80 lb-in).
