F 350 2WD Super Duty V10-6.8L (2009)
5. Remove the RH and LH A-pillar trim panels. For additional information, refer to A-Pillar Trim Panel See: Trim Panel/Service and
Repair/A-Pillar Trim Panel.
6. Remove the RH and LH B-pillar trim panels. For additional information, refer to B-Pillar Trim Panel - Crew Cab See: Trim Panel/Service and
Repair/B-Pillar Trim Panel - Crew Cab.
7. Remove the RH and LH rear garment hooks.
-
Open the rear garment hook screw access covers.
-
Remove the 2 rear garment hook screws.
8. Lower the glove compartment.
1. Open the glove compartment.
2. Depress the glove compartment stop and lower the glove compartment.
9. Through the glove compartment opening, disconnect the headliner electrical connector that is located at the RH instrument panel, toward the front
of the vehicle.
10. Remove the RH and LH rear assist handles.
1. Remove the 4 covers (2 on each handle).
2. Remove the 4 bolts (2 on each handle).
-
To install, tighten to 12 Nm (106 lb-in).
3. Remove the 2 B-pillar assist handles.
11. Remove the RH and LH C-pillar trim panels. For additional information, refer to C-Pillar Trim Panel - Crew Cab See: Trim Panel/Service and
Repair/C-Pillar Trim Panel - Crew Cab.
12. If equipped, remove the roof opening panel trim.
13. Remove the 3 headliner pushpin retainers.
14. Remove the rear window.
15. NOTICE: Make sure not to crease the headliner when removing it from the vehicle.
