F 350 2WD Super Duty V10-6.8L (2009)
Remove the shoulder safety belt guide.
1. Position the shoulder safety belt guide cover upward.
2. Remove the shoulder safety belt guide bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the shoulder safety belt guide.
4. Position aside the rear door opening weatherstrips.
5. Remove the safety belt anchor.
-
Remove the safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Remove the safety belt anchor.
6. Remove the C-pillar trim panel.
-
Route the safety belt and the shoulder safety belt guide through the C-pillar trim panel opening.
7. NOTICE: To avoid damage to the C-pillar trim panel, remove any retaining clips from the body and attach them to the C-pillar trim
panel before installing.
To install, reverse the removal procedure.
Cab Rear Trim Panel - Crew Cab
Cab Rear Trim Panel - Crew Cab
Removal and Installation
1. Remove the rear center safety belt retractor. For additional information, refer to Seat Belt Systems.
2. Remove the RH and LH C-pillar trim panels. For additional information, refer to C-Pillar Trim Panel - Crew Cab See: C-Pillar Trim Panel - Crew
Cab.
3. Remove the 2 cab rear trim panel pushpin retainers.