F 350 2WD Super Duty V10-6.8L (2009)
and the scan tool must be connected to the vehicle. For additional information, refer to Anti-Theft Security Access See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Component Tests and General Diagnostics.
4. Once in security access, select: "program unlimited key code" and follow the on-screen instructions. Enter the 8-digit code chosen by the customer
in Step 1 of this procedure and follow the on-screen instructions.
5. Select: "unlimited key mode ON" and follow the on-screen instructions.
6. Select: "Ignition Key Code Erase" and follow the on-screen instructions.
7. Disconnect the scan tool and turn the ignition switch to off.
8. Insert the first Passive Anti-Theft System (PATS) key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.
9. Turn the first PATS key to the OFF position and remove the key from the ignition lock cylinder.
10. Insert the second PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.
11. If it is desired to program additional key(s), refer to Key Programming Using Two Programmed Keys See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Key Programming Using Two Programmed Keys
for each additional key that needs to be programmed.
Disabling Unlimited Key Mode
NOTE: By disabling the unlimited key mode, the previous access code no longer operates the vehicle.
1. From the scan tool, enter TOOLBOX. Select BODY - SECURITY - PATS Functions and follow the on-screen instructions to ENTER
SECURITY ACCESS. This procedure takes approximately 10 minutes to carry out, during which time the ignition key must be in the ON position
and the scan tool must be connected to the vehicle. For additional information, refer to Anti-Theft Security Access See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Component Tests and General Diagnostics.
2. Select: "unlimited key mode OFF" and follow the on-screen instructions.
3. Select: "Ignition Key Code Erase" and follow the on-screen instructions.
4. Disconnect the scan tool and turn the ignition switch to off.
5. Insert the first PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.
6. Turn the first PATS key to the OFF position and remove the key from the ignition lock cylinder.
7. Insert the second PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.
8. NOTE: With the unlimited key mode turned off, a maximum of 8 keys can be programmed into the IC using the Key Programming Using Two
Programmed Keys See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and
Relearning/Key Programming Using Two Programmed Keys procedure. The PID SPAREKEY must be enabled.
If it is desired to program additional key(s), refer to Key Programming Using Two Programmed Keys See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Key Programming Using Two Programmed Keys
for each additional key that needs to be programmed. The PID SPAREKEY must be enabled.
Spare Key Programming - Using Diagnostic Equipment
Spare Key Programming - Using Diagnostic Equipment
NOTE: This procedure is used when a customer needs to have an additional key programmed into the vehicle without erasing stored key codes, but does
