F 350 2WD Super Duty V10-6.8L (2009)
Sunroof / Moonroof Panel: Service and Repair
Roof Opening Panel Shield
Roof Opening Panel Shield
Removal and Installation
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof
opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof
opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
1. Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass See: Roof Opening Panel Glass.
2. Remove the water trough.
1. Remove the 2 screws.
-
To install, tighten to 1 Nm (9 lb-in).
2. Remove the water trough.
3. Flex the opening shield to remove the guides from the tracks and remove the roof opening panel shield.
4. To install, reverse the removal procedure.
-
Align the roof opening panel. For additional information, refer to Roof Opening Panel Alignment See: Adjustments.
-
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.