F 350 2WD Super Duty V10-6.8L (2009)
Seat Cushion: Removal and Replacement
Seat Cushion - Rear, Crew Cab, 60/40 Seat
Seat Cushion - Rear, Crew Cab, 60/40 Seat
Removal and Installation
1. Remove the seat. For additional information, refer to Seat - Rear, Crew Cab, 60/40 Seat See: Service and Repair/Rear Seats/Seat - Rear, Crew
Cab, 60/40 Seat.
2. If equipped, remove 4 storage compartment strap screws.
-
To install, tighten to 25 Nm (18 lb-ft).
3. Remove the 2 bolts from the back side of the center support.
-
To install, tighten to 50 Nm (37 lb-ft).
4. Separate the 60 percent seat from the center support.
5. Remove the screw and side latch shield.
6. Remove the screw and cushion release handle.
7. Pry the side shield to release the 3 clips and remove the side shield.
8. Remove the 2 bolts and cushion assembly.
-
To install, tighten to 33 Nm (24 lb-ft).
9. Remove the bolt and seat cushion latch assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
10. To install, reverse the removal procedure.
Seat Cushion - Rear, SuperCab
Seat Cushion - Rear, SuperCab
Removal and Installation
1. Remove the seat. For additional information, refer to Seat - Rear, SuperCab See: Service and Repair/Rear Seats/Seat - Rear, SuperCab.
2. Pull up and remove the pivot cover.
3. Separate the affected RH or LH seat cushion assembly from the center support.
4. To install, reverse the removal procedure.
