F 350 2WD Super Duty V10-6.8L (2009)
Disassembly and Assembly
1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front, Bench See: Seat Back/Service and Repair/Removal and
Replacement/Front Seats/Seat Backrest - Front, Bench.
2. Remove the seat track. For additional information, refer to Seat Track - Front, Bench Seat See: Seat Track/Service and Repair/Seat Track - Front,
Bench Seat.
3. NOTE: One buckle shown, others similar.
Pull the safety belt (if equipped) and safety belt buckles through the cushion trim.
-
For driver safety belt buckle, separate the buckle switch electrical connector from the cushion frame.
4. Release all cushion trim cover J-clips attached to the cushion frame.
5. NOTE: Note the position of the latch cable for installation.
Release the latch cable retainers from the cushion frame and remove the latch cable.
6. Remove the cushion frame from the cushion foam pad.
7. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the seat cushion foam.
Remove the cushion trim cover from the cushion foam pad.
-
Invert the cushion trim cover and release the hook-and-loop strips.