F 350 2WD Super Duty V10-6.8L (2009)
1. Remove the wheel and tire.
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
-
To install, tighten bolt to 35 Nm (26 lb-ft).
3. NOTICE: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
Remove the 2 brake caliper bolts and the caliper.
-
To install (F-250/350 Single Rear Wheel (SRW), tighten to 35 Nm (26 lb-ft).
-
To install (F-350 Dual Rear Wheels (DRW), tighten to 76 Nm (56 lb-ft).
4. To install, reverse the removal procedure.
-
Install new copper washers.
-
Bleed the brake caliper.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
F-250/350 Vehicles Single Rear Wheel (SRW)
F-350/450 and 550 Dual Rear Wheels (DRW)