F 350 2WD Super Duty V10-6.8L (2009)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
All brake flexible hoses
1. With the vehicle in NEUTRAL, position it on a hoist.
Caliper brake flexible hose
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
-
To install, tighten to 35 Nm (26 lb-ft).
3. Remove the brake flexible hose bracket bolt and the brake flexible hose.
-
To install, tighten the bolt to 25 Nm (18 lb-ft).
Axle brake flexible hose
