F 350 2WD Super Duty V10-6.8L (2009)
Removal
1. Drain the fuel and turbocharger cooling system. For additional information, refer to Fuel and Turbocharger Cooling System Draining, Filling and
Bleeding See: Powertrain Management/Fuel Delivery and Air Induction/Service and Repair.
2. NOTE: The side bolt does not have to be removed to remove the fuel cooling system radiator.
Remove the cooling system radiator bolt. Remove the fuel cooling system radiator by sliding it up off the retainers.
Installation
1. NOTE: Do not tighten the fuel cooling system radiator bolt at this time. The fuel cooling system radiator must be removed and positioned
horizontally to manually bleed the fuel cooling system. Only install the bolt tight enough to ease connection of the coolant hoses to the fuel cooling
system radiator.
Position the fuel cooling system radiator and install the bolt.
-
If bleeding the fuel cooling system manually, tighten the bolt finger-tight.
-
If using the RADIATOR REFILLER to fill the fuel cooling system, tighten the bolt to 12 Nm (106 lb-in).
2. Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to Fuel and Turbocharger Cooling System Draining,
Filling and Bleeding See: Powertrain Management/Fuel Delivery and Air Induction/Service and Repair.
