F 350 2WD Super Duty V10-6.8L (2009)
NOTE: Install a new O-ring seal and lubricate with clean engine coolant.
Install the coolant pump and 4 bolts.
-
Tighten to 25 Nm (18 lb-ft).
2. Install the coolant pump pulley and 4 bolts.
3. Install the accessory drive belt.
4. Tighten the 4 bolts for the coolant pump pulley.
-
Tighten to 25 Nm (18 lb-ft).
5. Install the cooling fan. For additional information, refer to Cooling Fan - Gasoline Engine.
6. Fill the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding.
