F 350 2WD Super Duty V10-6.8L (2009)
3. Rotate the tensioner clockwise and remove the accessory drive belt.
4. Remove the crankshaft pulley bolt and washer.
-
Discard the crankshaft pulley bolt.
5. Using the Crankshaft Vibration Damper Remover, remove the crankshaft pulley.
Installation
1. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and Motorcraft
metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer.
Failure to follow this procedure may cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot in the crankshaft pulley.
2. NOTE: Lubricate the crankshaft front seal inner lip with clean engine oil prior to installing the crankshaft pulley.
Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.
