F 350 2WD Super Duty V10-6.8L (2009)
11. Remove the valve spring retainer and the valve spring.
12. Inspect the valve spring.
Installation
All valve springs
1. NOTICE: If the components are to be reinstalled, they must be installed in their original locations or engine damage may occur.
Using the Valve Spring Compressor, install the valve spring, the valve spring retainer and the valve spring retainer keys.
2. Relieve the air pressure from the cylinder.
3. NOTICE: If the components are to be reinstalled, they must be installed in their original locations or engine damage may occur.
NOTE: Do not allow the valve keepers to fall off the valve or the valve may drop into the cylinder. If a valve drops into the cylinder, the cylinder
head must be removed. For additional information, refer to Cylinder Head See: Service and Repair/Removal and Replacement/Cylinder Head -
Removal.
NOTE: It may be necessary to push the valve down while compressing the spring.
NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.
Using the Valve Spring Compressor, compress the valve spring and install the camshaft roller follower.
Cylinder No. 7 front intake valve spring
4. Position the camshaft bearing cap and install the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
5. Lubricate the balance shaft journals with clean engine oil.
