F 350 2WD Super Duty V10-6.8L (2009)
17. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.
18. Disconnect the LH Catalyst Monitor Sensor (CMS) electrical connector.
19. Disconnect the transmission wiring harness retainers and route the wiring harness over the top of the transmission and out of the way.
20. Remove the flexplate inspection cover.
1. Remove the 2 bolts.
2. Remove the inspection cover.
21. NOTICE: Support the transmission on the oil pan rails only or internal transmission damage can occur.
Install a Transmission Jack and raise the transmission.
22. Remove the 18 bolts and partially lower the oil pan.
23. Remove the 3 bolts and position the oil pump screen and pickup tube into the oil pan.
24. Remove the oil pan and the oil pump screen and pickup tube.
-
Discard the oil pan gasket.
-
Discard the oil pump screen and pickup tube O-ring seal.
Manual transmission equipped vehicles
25. Remove 18 oil pan bolts and position the oil pan onto the crossmember.
26. Remove the 3 bolts and position the oil pump screen and pickup tube into the oil pan.
27. Position the oil pan onto the engine and install 1 bolt at the front and 1 bolt at the rear of the oil pan to hold it in position.
28. Using the Engine Support Bar, Support Hook and Engine Support Bracket, align the engine support insulator studs and lower the engine.
