F 350 2WD Super Duty V10-6.8L (2009)
29. Remove the flywheel. For additional information, refer to Flywheel See: Service and Repair/Removal and Replacement/Flywheel.
30. Remove the rear engine cover.
31. Remove the 2 bolts, the oil pan and the oil pump screen and pickup tube.
-
Discard the oil pan gasket.
-
Discard the oil pump screen and pickup tube O-ring seal.
Installation
All vehicles
1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant. Failure to follow this
procedure may cause future oil leakage.
Inspect the oil pan. Clean the mating surface for the oil pan with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
2. NOTICE: Make sure to install a new O-ring seal. A missing or damaged O-ring seal can cause foam in the lubrication system and low oil
pressure. Failure to follow this instruction may result in engine damage.
NOTE: Clean and inspect the mating surfaces and install a new O-ring seal. Lubricate the O-ring seal with clean engine oil.
Install a new O-ring seal onto the oil pump screen and pickup tube.
3. Position the oil pump screen and pickup tube in the oil pan and position the oil pan and new gasket into the vehicle.
Manual transmission equipped vehicles
4. Position the oil pan onto the engine and install one bolt at the front of the engine and one bolt at the rear of the oil pan to hold it in position.
5. Install the rear engine cover.
6. Install the flywheel. For additional information, refer to Flywheel See: Service and Repair/Removal and Replacement/Flywheel.
7. Using the Engine Support Bar, Support Hook and Engine Support Bracket, raise the engine.
8. Remove the 2 bolts and lower the oil pan.
All vehicles
9. NOTICE: Make sure to install a new O-ring seal. A missing or damaged O-ring seal can cause foam in the lubrication system and low oil
pressure. Failure to follow this instruction may result in engine damage.
NOTE: Clean and inspect the mating surfaces and install a new O-ring seal. Lubricate the O-ring seal with clean engine oil prior to installation.
Position the oil pump screen and pickup tube and install the bolts.
