F 350 2WD Super Duty V10-6.8L (2009)
Install 3 new LH engine support insulator nuts.
-
Tighten to 200 Nm (148 lb-ft).
Automatic transmission equipped vehicles
19. Route the wiring harness over the top of the transmission and connect the wiring harness retainers.
20. Connect the CMS electrical connector.
21. Connect the TSS sensor electrical connector.
22. NOTE: Some vehicles are equipped with a catalytic converter delete pipe instead of a catalytic converter.
Install 2 new exhaust Y-pipe flange bolts and nuts.
-
Tighten to 40 Nm (30 lb-ft).
23. If equipped, position the skid plate and install the 4 bolts.
-
Tighten to 24 Nm (18 lb-ft).
24. Attach the fuel supply tube and the fuel vapor tube to the position retainer at the rear of the engine.
