F 350 2WD Super Duty V10-6.8L (2009)
5. Loosely install the bolts, then tighten the bolts in 2 stages, in the sequence shown.
-
Stage 1: Tighten to 20 Nm (177 lb-in).
-
Stage 2: Tighten an additional 60 degrees.
6. Connect the CKP sensor electrical connector.
7. Position the power steering pump and install the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).
8. Position the transmission cooler tube and starter electrical harness support brackets and install the nut.
-
Tighten to 25 Nm (18 lb-ft).
9. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the CMP sensor and the bolt.
