F 350 2WD Super Duty V10-6.8L (2009)
Hose/Line HVAC: Service and Repair
Compressor to Condenser Discharge Line
Compressor to Condenser Discharge Line - 5.4L and 6.8L
Removal and Installation
1. Recover the refrigerant.
2. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
3. Disconnect the high-pressure cutoff switch electrical connector.
4. Detach the wire harness clip from the compressor-to-condenser discharge line at the A/C compressor discharge fitting.
5. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the compressor-to-condenser discharge line.
7. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
