F 350 2WD Super Duty V10-6.8L (2009)
Fog/Driving Lamp Bulb: Service and Repair
Fog Lamp Bulb
Removal and Installation
WARNING: The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the
bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE: The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period
of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on the
fog lamps with the bulb removed from the fog lamp.
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the fog lamp electrical connector.
3. Rotate the fog lamp bulb counterclockwise approximately one-eighth turn and remove it.
4. To install, reverse the removal procedure.
