ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8847 > < Initial Inspection and Diagnostic Overview|Page 8845
Page 1
background image

Parking Lamp: Pinpoint Tests

Pinpoint Test P: One Or More Parking, Rear Or License Plate Lamps Is Inoperative

Parking, Rear and License Plate Lamps

Pinpoint Tests

Pinpoint Test P: One Or More Parking, Rear or License Plate Lamps Is Inoperative

Refer to Wiring Diagram Set 92, Parking, Rear and License Lamps for schematic and connector information.  See: Diagrams/Electrical
Diagrams/Diagrams By Number

Normal Operation

When the headlamp switch is placed in the PARKING LAMPS ON position, the Smart Junction Box (SJB) provides a ground for the parking lamp relay
coil (integrated into the SJB). When the parking lamp relay is energized, voltage is routed through circuit CLS30 (VT/WH) to the front, rear, license
plate, dual rear wheel marker, trailer tow exterior mirrors (if equipped) and cab marker lamps (if equipped). Ground is provided to the rear lamps and 
license plate lamps through circuit GD176 (BK/WH). Ground is provided to the LH front parking and side marker lamps through circuit GD122 (BK)
and the RH front parking and side marker lamps through circuit GD124 (BK/VT). Ground is provided to the trailer tow mirrors through circuit GD179
(BK/VT). Ground is provided to the cab marker lamps through circuit GD115 (BK/GY).

This pinpoint test is intended to diagnose the following:

-

Fuse

-

Wiring, terminals or connectors

-

Bulb holder

-

Rear lamp assembly (vehicles without pickup bed)

-

Cab marker lamp

-

Trailer tow exterior mirror (if equipped)

-

SJB

PINPOINT TEST P: ONE OR MORE PARKING, REAR OR LICENSE PLATE LAMPS IS INOPERATIVE

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.

-------------------------------------------------
P1 DETERMINE IF ALL THE PARKING LAMPS ARE INOPERATIVE

-

Ignition OFF.

-

Place the headlamp switch in the PARKING LAMPS ON position.

-

Are all the parking lamps inoperative?

Yes

VERIFY the SJB fuse 22 (15A) is OK. If not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short.

If OK and the vehicle is equipped with cab marker lamps, GO to P9.

If OK and the vehicle is not equipped with cab marker lamps, VERIFY the SJB fuse 22 (15A) is OK. GO to P2.

No

If the cab marker lamps are illuminated and all the remaining parking lamps are inoperative, GO to P2.

If all the cab marker lamps are inoperative, GO to P3.

If both trailer tow mirrors are inoperative, GO to P5.

For any other inoperative lamp, GO to P7.

-------------------------------------------------
P2 CHECK THE PARKING LAMP SUPPLY VOLTAGE CIRCUIT FOR AN OPEN (FRONT LAMPS)

Initial Inspection and Diagnostic Overview|Page 8847 > < Initial Inspection and Diagnostic Overview|Page 8845