F 350 2WD Super Duty V10-6.8L (2009)
4. NOTE: The jumper line can be serviced separately. It is not necessary to remove the jumper line from the hydraulic booster when servicing the
pressure line.
Disconnect the power steering pressure line-to-jumper line fitting.
-
To install, tighten to 62 Nm (46 lb-ft).
5. Remove the pressure line bracket/pump bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Unclip the power steering pump pressure line from the 3 pressure line retainers.
7. Disconnect the pressure line-to-pump fitting and remove the power steering pump pressure line.
-
To install, tighten to 35 Nm (26 lb-ft).
8. To install, reverse the removal procedure.
9. Fill the power steering system.
