F 350 2WD Super Duty V10-6.8L (2009)
7. Using the Handle and Wheel Hub Outer Bearing Cup Remover, drive the outer bearing cup from the wheel hub and discard the cup.
Installation
1. With the wheel hub facing upward, position the new outer bearing cup in the wheel hub bore and place the Handle and Axle Bearing Installer on
the bearing cup.
2. Using the Handle and Axle Bearing Installer, drive the outer bearing cup into the fully seated position.
3. Reposition the wheel hub facing downward. Position the inner bearing cup in the wheel hub bore and place the Handle and Axle Bearing Installer
on the bearing cup.
