F 350 2WD Super Duty V10-6.8L (2009)
Engine Control Module: Customer Interest
Engine Controls - ECM Update For Various Concerns
TSB 11-1-3
4.0L / 5.4L / 6.8L - CALIBRATION UPDATE - VARIOUS ISSUES
FORD:
2009-2010 Mustang
2008-2010 F-250, F-350
This article supersedes TSB 10-25-8 to update the Part List.
ISSUE
Some 2009-2010 Mustang vehicles equipped with 4.OL engine and built on or before 2/9/2010, may exhibit a malfunction indicator lamp (MIL)
illumination with diagnostic trouble code (DTCs) P0607.
Some 2008-2010 F-Super Duty 250-350 vehicles equipped with 5.4L and 6.8L engines and may exhibit any of the following symptoms: Audible noise or
rattle from the Catalytic Convertors, Lacks power and MIL illumination with one or more the following DTCs: P0420, P0430, P0148, P0191, P0607 or
PO61B.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
Mustang:
This article applies if DTC P0607 is present.
1. Reprogram the powertrain control module (PCM) to the latest calibration using IDS release 69.02 and higher. This new calibration is not included in
the VCM 2010.9 DVD. Calibration files may also be obtained at the website.
F-Super Duty 250/350
This service update was previously addressed by Customer Satisfaction Program 10M05 for all United States, Canada and should not be submitted as a
warranty claim.
1. Is the vehicle an F-Super Duty 250-350 Chassis Cab, equipped with a 6.8L engine?
a. No - Go to Step 2.
b. Yes - Perform the following:
(1)
If 2008 F-Super Duty 250-350 Chassis Cab, equipped with a 6.8L engine and has DTC P0607 or P061B, Go to Step 4.
(2)
If 2008 F-Super Duty 250-350 Chassis Cab, equipped with a 6.8L engine and has any other DTC, continue with normal diagnostics.
(3)
If 2009-2010 F-Super Duty 250-350 Chassis Cab, equipped with a 6.8L engine and has DTCs P0607 or P061B, this procedure does not
apply, continue with normal diagnostics.
2. If an audible noise or rattle concern from the Catalytic Converters, replace the exhaust catalyst y-pipe. Refer to Workshop Manual (WSM), Section
309-00.
3. Using IDS retrieve DTCs.
a. If P0420 or P0430 are present or pending, replace the exhaust catalyst y-pipe. Refer to WSM, Section 309-00. Continue to Step 4.
b. If DTCs P0420 or P0430 are not present or pending, refer to WSM or Powertrain Control/Emissions Diagnosis Manual for normal diagnostics.
4. Reprogram the PCM to the latest calibration using IDS release 69.02 and higher. This new calibration is not included in the VCM 2010.9 DVD.
Calibration files may also be obtained at the website.
