F 350 2WD Super Duty V10-6.8L (2009)
ISO 9141 Network Operation
The ISO 9141 communications network is a single wire network, used for diagnostic purposes only.
The ISO 9141 communications network is used for the following modules:
-
4X4 control module
-
PAM
Medium Speed Controller Area Network (MS-CAN) Operation
The MS-CAN communicates using bussed messages. The MS-CAN has an unshielded twisted pair cable, data bus (+) and data bus (-) circuits. In
addition to scan tool communication, this network allows sharing of information between all modules on the network.
The MS-CAN is a communication network used for the following modules:
-
ACM
-
Accessory Protocol Interface Module (APIM)
-
CDIM
-
RETM
-
DSM
-
HVAC module
-
IC
-
SDARS module
-
SJB
High Speed Controller Area Network (HS-CAN) Operation
The HS-CAN communicates using bussed messages. The HS-CAN uses an unshielded twisted pair cable, data bus (+) and data bus (-) circuits. In
addition to scan tool communication, this network allows sharing of information between all modules on the network.
The HS-CAN is a communication network used for the following modules:
NOTE: The EVRT actuator does not communicate with the scan tool.
-
ABS module
