ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3148 > < Initial Inspection and Diagnostic Overview|Page 3146
Page 77
background image

-------------------------------------------------
V16 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED

-

Disconnect: APIM C3342.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to V17.

No

CONNECT all modules. CONNECT the negative battery cable. GO to V36.

-------------------------------------------------
V17 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IC DISCONNECTED

-

Disconnect: IC C220.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an RETM, GO to V18.

If the vehicle is not equipped with an RETM, GO to V19.

No

CONNECT all modules. CONNECT the negative battery cable. GO to V37.

-------------------------------------------------
V18 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE RETM DISCONNECTED

-

Disconnect: RETM C949.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

Initial Inspection and Diagnostic Overview|Page 3148 > < Initial Inspection and Diagnostic Overview|Page 3146