F 350 2WD Super Duty V10-6.8L (2009)
Fuel Cooler: Service and Repair
Fuel Cooler
Removal
1. Drain the fuel and turbocharger cooling system. For additional information, refer to Fuel and Turbocharger Cooling System Draining, Filling and
Bleeding See: Service and Repair.
2. Release the low-pressure fuel system pressure.
3. Disconnect the fuel cooler-to-coolant expansion tank hose at the fuel cooler.
4. Disconnect the coolant pump-to-fuel cooler hose at the fuel cooler.
5. Remove the banjo bolt and disconnect the fuel cooler-to-fuel filter fuel tube.
-
Remove and discard the sealing washers.
6. Remove the banjo bolt and disconnect the fuel pump-to-fuel cooler fuel tube.
-
Remove and discard the sealing washers.
7. Remove the 2 bolts, the 2 stud bolts, the 2 nuts and the fuel cooler.
Installation
1. Position the fuel cooler and install the 2 bolts, the 2 stud bolts and the 2 nuts.
-
Tighten the 2 bolts, 2 stud bolts and the 2 nuts in 3 stages.
-
Stage 1: Tighten the nuts to 19 Nm (168 lb-in).
-
Stage 2: Tighten the stud bolts to 24 Nm (18 lb-ft).