F 350 2WD Super Duty V10-6.8L (2009)
1. Relieve the fuel pressure. For additional information, refer to Fuel System Pressure Release - Gasoline Engines See: Fuel Filter/Fuel Pressure
Release/Service and Repair or Fuel System Pressure Release - Diesel Engine See: Fuel Filter/Fuel Pressure Release/Service and Repair.
2. Disconnect the battery ground cable.
3. Remove the fuel tube safety clip.
4. Install the Spring Lock Coupling Disconnect Tool.
5. Close and push the Spring Lock Coupling Disconnect Tool into the open side of the cage.
6. Separate the spring lock coupling.
Connect - Type I
1. NOTE: Apply clean engine oil to the O-ring seals.
Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs if necessary.
2. NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.