F 350 2WD Super Duty V10-6.8L (2009)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Functional
Ignition Lock Cylinder - Functional
Removal and Installation
1. Remove the 3 screws and the lower steering column shroud.
2. Remove the Passive Anti-Theft System (PATS) transceiver (if equipped).
3. Remove the ignition lock cylinder.
1. Insert the ignition key and turn to the RUN position.
2. Using a suitable tool, press the ignition lock cylinder release pin through the access hole while pulling out the ignition lock cylinder.
4. For vehicles equipped with PATS, if a new lock cylinder with keys is replaced, the new PATS keys must be programmed. For additional
information, refer to Key Programming Using Diagnostic Equipment in Antitheft and Alarm Systems. See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Key Programming Using Diagnostic Equipment
5. To install, reverse the removal procedure.
-
Verify ignition lock cylinder operation.
