F 350 2WD Super Duty V10-6.8L (2009)
Shift Solenoid: Service and Repair
TorqShift
Shift Solenoids (SS)
Removal and Installation
NOTE: Some solenoid body bolts and wire loom bolts will need to be removed in order to remove affected solenoids.
NOTE: The Pressure Control Solenoid A (PCA) (line pressure solenoid) is not serviced in the vehicle. The solenoid body will need to be removed to
remove the PCA. For additional information, refer to Solenoid Body Assembly See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Valve Body/Service and Repair.
1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter See:
Maintenance/Filters/Fluid Filter - A/T/Service and Repair/Fluid Pan, Gasket and Filter.
2. Disconnect the affected shift solenoid connector.
3. Remove the affected shift solenoid.
1. Remove the retaining E clip.
2. Remove the affected shift solenoid.
4. To install, reverse the removal procedure.