F 350 2WD Super Duty V10-6.8L (2009)
3. NOTE: Leave a small portion of the pin exposed.
Install the manual control lever shaft retaining pin into the case.
4. NOTE: When the manual control valve detent lever shaft retaining pin is installed correctly, 2 mm (0.08 in) of the pin will be exposed.
Install a new manual control valve detent lever shaft retaining pin.
5. Tighten the bolts to 10 Nm (89 lb-in).
6. Connect the TR sensor.
7. Connect the selector lever cable end.
8. Install the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter See:
