F 350 2WD Super Duty V10-6.8L (2009)
-
Description: a description of the content of the software revision
-
History - Software
-
Date/Time: date and time of any recorded software installation
-
VIP: VIP software that was installed at that time
-
CIP: CIP software that was installed at that time
-
Description: a description of the content of the software revision
-
Available Software for Programming
-
Select: allows the software package to be selected
-
Lineage: the original software release, if the software available is a revision
-
VIP: VIP software level that is available with the selection
-
CIP: CIP software level that is available with the selection
-
Description: a description of the content of the software revision
9. Click a CIP software level to view the device compatibility list associated with the CIP software level, if desired.
10. To exit the APIM software level check, disconnect the scan tool from the DLC and the USB port, or exit the OASIS screen.
Audio Control Module (ACM) Self-Diagnostic Mode
Audio Control Module (ACM) Self-Diagnostic Mode
Audio Systems Without Navigation
1. Turn the Audio Control Module (ACM) on.
2. Operate the audio system in radio tuner (AM/FM) mode.
3. Press and hold preset buttons 3 and 6 for 3 seconds until the speaker walk test begins.
-
The display indicates each speaker as it is tested.
4. NOTE: If the speaker walk test is the only test required, this procedure can be stopped after step 3 by turning the ACM off.
Before the speaker walk test is complete, carry out any of the following actions:
