F 350 2WD Super Duty V10-6.8L (2009)
Power Door Lock Control Module: Service and Repair
Door Latch Remote Control - SuperCab
Door Latch Remote Control - SuperCab
Removal and Installation
1. Remove the rear speaker.
2. Position the water shield aside.
3. Remove 3 upper rear door latch screws.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove 3 lower rear door latch screws.
-
To install, tighten to 12 Nm (106 lb-in).
5. NOTICE: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal. Make sure not to exceed a
6.35 mm (0.25 in) drill bit.
Remove the rear door latch remote control.
1. Disconnect the actuating rods.
2. Remove the rivets.
6. To install, reverse the removal procedure.
